Victron – BlueSmart battery Chargers

$151.80$381.70

The Blue Smart IP65 Charger is the new professional battery charger with built-in bluetooth. The Blue Smart IP65 Charger can be used on devices in your workshop and on motor vehicles, such as (classic) cars; motorbikes; boats and camper-vans.

Features:
Water, dust and chemical resistant
Seven step smart charge algorithum
Recovery of fully discharged ‘dead’ batteries
Automatic power supply function
Severe cold performance: down to -30 degress celcius
Several other battery life enhancing features
Low power mode to charge smaller batteries
Li-ion battery mode
Setup and configure, readout of voltage and current by Bluetooth Smart

Clear

FEATURES
Reconditioning

A lead-acid battery that has been insufficiently charged or has been left discharged during days or weeks will deteriorate due to sulfation. If caught in time, sulfation can sometimes be partially reversed by charging the battery with low current up to a higher voltage.

Recovery function for fully discharged batteries
Most reverse polarity protected chargers will not recognise, and therefore not recharge a battery which has been discharged to zero or nearly zero Volts. The Blue Smart IP65 Charger however will attempt to recharge a fully discharged battery with low current and resume normal charging once sufficient voltage has developed across battery terminals.

Ultra high efficiency “green” battery charger
With up to 95% efficiency, these chargers generate up to four times less heat when compared to the industry standard. And once the battery is fully charged, power consumption reduces to 0.5 Watt, some five to ten times better than the industry standard.

Durable, safe and silent
Low thermal stress on the electronic components.
Protection against ingress of dust, water and chemicals.
Protection against overheating: the output current will reduce as temperature increases up to 60 degress celcius, but the charger will not fail.
The chargers are totally silent: no cooling fan or any other moving parts.

Storage mode: less corrosion of the positive plates

Even the lower float charge voltage that follows the absorption period will cause grid corrosion. It is therefore essential to reduce the charge voltage even further when the battery remains connected to the charger during more than 48 hours.

Temperature compensated charging
The optimal charge voltage of a lead-acid battery varies inversely with temperature. The Blue Smart IP65 Charger measures ambient temperature during the test phase and compensates for temperature during the charge process. The temperature is measured again when the charger is in low current mode during folat or storage.

Li-ion battery mode
The Blue Smart IP65 Charger uses a specific charging algorithum for Li-ion batteries, with automatic Li-ion under voltage protection reset.